Social Icons

Pages

Tuesday, 27 November 2012

How to make scooter faster - Tips for increasing speed of scooter

Everyone wants to make his scooter more faster than it’s normal speed. So here are some method for increasing speed, some are cheaper and some are expensive.

Here’s my favorite technique for increasing speed of scooter.

Remove the fuel filter, your scooter will go faster because the engine can get more fuel.. what crap. This would only be true if your fuel filter was completely blocked and your engine wasn't getting any fuel. If this was happening you'd know about it!

Tuning:
Having your carb(Carburetor) tuned properly will allow you to get the most out of your motorized scooter. If your scooter isn't tuned properly, it will 'bog' down when you try and accelerate or it may accelerate well but die at 2/3 revs rather than going to full revs.

Replace your air filter:
This may seem unnecessary, but it is a very important step. By removing your moped scooter air filter and replacing it with an expansion chamber or a higher performance muffler, you can actually increase the speed of the moped scooter. This is a simple remove and replace step and should not need any tools other than a screwdriver.

Advance the timing:
When you advance the timing you cause the spark plug to ignite the fuel a little earlier which helps burn the fuel better. Be careful, once you change the timing its hard to get it back to the original setting. I've heard however that advancing the timing on a scooter with an expansion chamber and high performance carb will actually decrease performance.

Raising the compression:
1. Remove the washer around the spark plug and then stop any leaks with liquid gasket cement.
I've personally tried this one and I wouldn't do it again.

2. Remove the head gasket from the motor. This will lower the cylinder and reduce the gap between the top of the piston and the spark plug. You can use liquid gasket cement to replace the old cardboard gasket. Have fun with this one!

3.The third and the best technique I've seen is to take your motor into a small engine shop and get about 20 thousands of an inch machined off the base of the cylinder. This allows you to keep your normal head gasket rather than removing it and replacing it with liquid head gasket cement which can leak.

Changing the gear ratio:
Changing the drive ration will change the acceleration (get up & go) and top speed of your scooter. On scooters such as Go-Ped, Martin Monster and OZ scooters which use a spindle on tyre drive technique, changing the diameter of the spindle will change the drive ratio of the scooter. The larger the diameter of the spindle, the more top end. The smaller the spindle the more low end grunt and acceleration it will have. With scooters driven by chain and/or reduction gearbox (VIZA VIPER, VENOM, CRUZE also sold under the Tami name) changing the rear sprocket size on the rear wheel will change the drive ratio.

Expansion chamber pipes:
Expansion Chamber Pipes, racing pipes or whatever you want to call them give a marked increase in horsepower. Different pipes are required for each engine to obtain the maximum benefit out of them. Racing pipes can also be tuned to give maximum increase at either low or high revs. Racing pipes will make the engine run hotter so caution should be taken in hot weather.

Turbo:

Using forced air induction will boost performance by forcing more air in, more fuel into the motor giving your scooter more go.

14 comments:

  1. Thanks for sharing this information.It will be helpful for others.
    regards
    helen
    Nitrotek

    ReplyDelete
  2. I needed this. Very informative and quite easy to navigate! Thanks for thinking of us.
    funique

    ReplyDelete
  3. nice blog. thanks for sharing this nice blog. i am sure that you this information will help people to make their scooter better.
    Adam smith
    adam.smith402@yahoo.com
    Nitrotek.se

    ReplyDelete
  4. awesome tips dear,I was looking for this kind of information on internet for few days. Actually my scooter have problem of speed. I have found your information very helpful. Thanks for sharing.
    ....Read more
    Regards,
    Berry

    ReplyDelete
  5. Thanks for sharing. I want to make my scooter more faster. These tips useful to scooter lover. Find out more here


    Regards,

    ReplyDelete
  6. very nice you are absulutly right Everyone wants to make his scooter more faster than it’s normal speed and the tips for increasing the speed of his scooter are very nice thanks for such a nice information.
    see more

    ReplyDelete
  7. This comment has been removed by the author.

    ReplyDelete
  8. Thanks for sharing nice information.It will be very helpful for me and others.
    Regards
    Nitrotek

    ReplyDelete
  9. Nice tips. I learnt so much about how to increase speed. I never experienced that so it really helps me to know what exactly to do before start making my scooter more faster. Thanks for the informative post keep up the good work. For more Visit Nitrotek

    ReplyDelete
  10. I was looking for this kind of tutorial on internet for few days. Actually my scotter also have problem of speed. I have found your tutorial very helpful. Thanks for sharing.
    Sid
    Nitrotek

    ReplyDelete
  11. we should change engine oil on the time .it would also effect on the speed .
    you provide very good information , thanks for sharing ,
    best regards ,
    Find out more here

    ReplyDelete
  12. Hey I am using an 110 cc maped its top speed is 80 wat shall I do for get more speed without changing its sound

    ReplyDelete
  13. I greatly enjoyed reading your article :) Please continue publishing helpful topics like this. Regards, from Scooters 'N Chairs.

    ReplyDelete
  14. Thanks a lot sir...seems very helpful tips

    ReplyDelete